VMware VCLOUD SDK 1.0 - FOR PHP DEVELOPERS GUIDE Manuel d'utilisateur télécharger pdf (Page 15)

If you watch the console of the NAS VM you may see messages about not having enough RAM for ZFS, this

does not cause any issues and can be ignored

In the Automate folder you will find Automate.ini. This file allows even more automation but is mostly for my

use. The VCInstall, BuildDatastores, BuildVM and Product Key lines answer the questions in the VC server build

and Add Hosts scripts. The TZ line allows the automatic setting of the Time Zone in the Windows VMs, it uses

the TZUtil command, to get the right text for this run “tzutil /g” on your PC and paste the result in place of my

time zone. The View section allows the automation of the View connection servers and security server along

with the setup of the nested Windows XP VM that can be used as a desktop for View. There are some

additional actions required for View so check the section later in this document.

Do not move on to Task 2 until the build share is fully populated.

Task 2 – Build DC, Windows Infrastructure

On both the VC and DC VMs make sure the CDROM drive is connected to a Windows Server 2008 R2 install

ISO, connected at power on is recommended. Also make sure that the right floppy image is connected, boot

floppy images can be found on the build share in \Automate\BootFloppies. The boot floppies only work with

Windows 2008R2 SP1 ISO files, using the RTM ISO (no service pack) will result in a failed install

Power on the DC VM to start the unattended install.The first time you boot this VM it has a blank hard disk, so

it will boot from the Windows installer CD and begin the build process. On subsequent reboots the installer

will pass boot over to the hard disk unless you press a key, pressing a key at this prompt will completely

rebuild the VM with no confirmation.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 48 49

Pas de commentaire

VMware VCLOUD SDK 1.0 - FOR PHP DEVELOPERS GUIDE Manuel d'utilisateur Page 15