VMware PACKAGE MANAGER 1.1 Manuel d'utilisateur télécharger pdf (Page 30)

Installing for RHEL 6 or CentOS 6

3. Click Submit.

The Step 2: Specify or Discover Devices to Monitor panel appears.

Figure 3.3. Setup Wizard: Step 2 (Manual Add)

3.5.2. Add Devices

You can add devices manually, or give Resource Manager network or IP address range information so it can

discover your devices.

3.5.2.1. Adding Devices Manually

Follow these steps to manually add devices to the system. For each device you want to add:

1. Enter a fully qualified domain name or IP address

2. In the Details area, select a device type from the list. If your device type is not listed, then use the default

selection. (You can change device classes for a device later, as well as add device classes.)

3. Enter the appropriate credentials used to authenticate against the device.

Note

For more information about setting credentials, refer to Resource Manager Administration.

4. To add the devices, click Submit.

Resource Manager models the devices in the background.

Note

You can bypass device addition through the wizard. Click Skip to the dashboard to go directly to the

Resource Manager Dashboard. Later, you can add devices by following the steps outlined in Resource

Manager Administration.

3.5.2.2. Discovering Devices

To discover devices:

1. Select the Autodiscover devices option.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 68 69

Pas de commentaire

VMware PACKAGE MANAGER 1.1 Manuel d'utilisateur Page 30