VMware VC-SRM4-A - vCenter Site Recovery Manager Manuel d'utilisateur télécharger pdf (Page 48)

TECHNICAL WHITE PAPER / 48

VMware vCenter Site Recovery Manager 5.0

Evaluation Guide

Figure 44. Network Recovery Properties

Custom network information can be conﬁgured for both the protected and recovery sites. This may be of use

if reprotection and automated failback will be used (both of which are only applicable to array-based



dr-ip-customizer will be of much greater importance for populating mass changes to IP information in VM

conﬁgurations, but is out of the scope of this evaluation.

Step 7: Conﬁgure priority groups and dependencies

SRM includes the ability to set priorities for virtual machines within a recovery plan, as well as the ability of

dependencies to set policies around startup sequences for VMs or sets of VMs. Priority groups will dictate which







within a priority group that will enable the administrator to dictate (as a property of a VM itself) which VMs must

be running prior to attempting to start the VM with the dependency. This enables multitier applications to have

a controlled start sequence.

 TosetvirtualmachinesaspartofaspeciﬁcprioritygroupclicktheVMwithinarecoveryplanandclick

ConﬁgureRecoveryasthoughselectingcustomIPaddressingOncethepropertiespop-upmenuisopen

clickonPriorityGroup

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 118 119

Pas de commentaire

VMware VC-SRM4-A - vCenter Site Recovery Manager Manuel d'utilisateur Page 48