VMware VMWARE CLOUD DIRECTOR 1.0 - TECHNICAL NOTE Spécifications télécharger pdf (Page 37)

TECHNICAL WHITE PAPER / 37

VMware vCloud Director 5.1 Evaluation Guide

When it is connected to the console, log in with the username admin and the password default. Type the

command “enable” to enter the privileged mode.

Provide the password default again. At the prompt, type “setup” to start the initial conﬁguration process.

When prompted, enter the appropriate values for the vCloud Networking and Security Manager IP address,

netmask and DNS information.

To save the new conﬁguration, verify the information entered and answer “y” when prompted. At the prompt,

type the command “exit” to log out. Then close the console window.

At this point, we can use a Web browser and connect the vCloud Networking and Security Manager user

interface using the IP address speciﬁed to complete the initial conﬁguration. It might take a couple of minutes for

the previous step to complete before you can access the vCloud Networking and Security Manager user interface.

When connected to the vCloud Networking and Security Manager interface, log in with the username “admin”

and the default password “default.”

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 79 80

Pas de commentaire

VMware VMWARE CLOUD DIRECTOR 1.0 - TECHNICAL NOTE Spécifications Page 37