VMware VCLOUD REQUEST MANAGER 1.0.0 Guide de l'utilisateur télécharger pdf (Page 13)

Technical white paper

The events captured from the log4j application logs will be sent to the HP ArcSight Logger and then select events can be

configured and forwarded to the HP ArcSight ESM manager via the Logger2ESM connector described earlier. The

“log4j.appender.cef1.hostName=192.x.x.x” line in the log4j.properties file specifies the HP ArcSight Logger IP Address. A

corresponding UDP receiver (UDP Receiver 1) was created on the HP ArcSight Logger to receive the events that are sent

from each application.

Matrix Operating Environment

HPIO events have been configured for logging through the procedures described in the Integration with ArcSight document

and operating system events are captured by the HP ArcSight Connector. This next section will describe how to configure

logging for the c7000 Onboard Administrator and HP Virtual Connect.

HP BLc7000 Onboard Administrator

To enable a HP BLc7000 Onboard Administrator (OA) to be monitored and viewed in HP ArcSight Logger and ESM, you need

to point the internal system log of the OA to the HP ArcSight Logger. To complete this action, perform the following:

• Active Onboard Administrator -> System Log -> Log Options

– Select “Enable remote system logging”

– Syslog Server Address: <IP of your HP ArcSight Logger>

– Port: <Port of Logger’s UDP Receiver (default: 514)>

Figure 12. Onboard Administrator Logging

• Select “Apply” to apply the settings.

• Once the screen refreshes, you can select “Test Remote Log”. By doing so, a test message is sent to the Logger. If

everything is working, you should see the IP or the host name of the HP Onboard Administrator registered in HP ArcSight

Logger in the “Configuration -> Devices” page (Figure 6).

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 38 39

Pas de commentaire

VMware VCLOUD REQUEST MANAGER 1.0.0 Guide de l'utilisateur Page 13