VMware VSPHERE CLIENT 4.0 - UPGRADE GUIDE UPDATE 1 Manuel d'utilisateur Page 31

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 168
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 30
3BSE056141-510 F 31
Section 4 Installation and Configuration
This section describes how to install and configure the VMware ESX(i) server and
the vSphere Client software for virtual 800xA server nodes. For general information
about the VMware ESX server installation, refer to the VMware ESX Server 4.1 Get
Started manual.
http://www.vmware.com/pdf/vsphere4/r41/vsp_41_esx_get_start.pdf
For the VMware ESXi Server 5.0 Installation Guide, refer to vSphere Installation
and Setup manual.
http://pubs.vmware.com/vsphere-50/topic/com.vmware.ICbase/PDF/vsphere-esxi-
vcenter-server-501-installation-setup-guide.pdf
VMware ESXi 5.0 Server Installation
Many modern servers are designed with internal USB or SD slots. When extracted
with a memory device, they can be used for the installation destination of ESXi.
Perform the following to install VMware ESXi server software:
1. Start the standard installer from the ESXi installer (Figure 7).
2. From the Welcome to the VMware ESXi 5.0.0 Installer window, press Enter to
Install (
Figure 8).
3. Read the End User License Agreement, then click press F11 to accept and
continue (
Figure 9).
While servers can come pre-installed in the ESXi, the following outlines the
procedure for a new installation.
The following procedure is only for new installations. It is not recommended to
upgrade though it is available, due to the possible interference with the
configurations in the ESX(i) servers.
Vue de la page 30
1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 167 168

Commentaires sur ces manuels

Pas de commentaire