VMware vCenter Site Recovery Manager 4, 1 CPU Spécifications télécharger pdf (Page 49)

EVALUATOR’S GUIDE

VMWA RE VCENTER SI TE RECO VERY MANAGER 4.0

4949

Figure 56: Review Site 1 storage

Figure 56

successfully to the array at Site 2.

Figure 57: Review Site 2 storage

Figure 57

datastore was placed into this mode during the Site Recovery Manager recovery plan being executed in ‘Run’

mode to perform the failover.

3. Reverse storage replication so that replication now flows from Site 2 to Site 1 for the NFS export

the virtual machine resides in. Before failback can be discussed from Site 2 to Site 1, the storage array

replication needs to be reconfigured to replicate in that direction. Depending on the storage array

replication technology being used your array may do this automatically if the Site 1 array is still available

and responding (known as a dynamic swap). In most cases you will need to work with your storage

teams to reverse the storage replication.

4. Configure Site Recovery Manager SRAs within Site 2 Site Recovery Manager server



original state Site 1 will be the protected site and Site 2 will be the recovery site. This was the case for

this example. In this kind of deployment there is no need -during the initial setup to configure the array

managers or the inventory mappings within the Site Recovery Manager server at Site 2 until a failback

operation is to be performed. This will typically look like Figure 58.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 64 65

Pas de commentaire

VMware vCenter Site Recovery Manager 4, 1 CPU Spécifications Page 49