
OneCommand™ Manager Application P007997-01A Rev. B
2. Installing and Uninstalling OneCommand Manager Application Components
Installing the OneCommand Manager Application
19
Note: You can also install the OneCommand Vision Sensor, but you must have the
Windows SNMP service installed or the sensor installation will fail.
Figure 2-2 Management Mode Dialog Box
5. During installation the Management Mode dialog box appears. Choose the
management mode you want and click OK. See “Changing Management and
Read-Only Mode” on page 39 for more information about configuring management
mode.
6. Check or uncheck the Enable TCP/IP Management checkbox to enable or disable
remote management over TCP/IP. You can also change the TCP/IP port used
(23333 is the IANA registered port for Emulex).
7. The Installation Completed window appears when the installation is finished. Click
Finish. A shortcut is added to the Start menu. You do not need to reboot the system.
Unattended Installation in Windows
To install the OneCommand Manager application in Windows:
1. From the Emulex website, download the x64 or x86 OneCommand Manager
Enterprise Kit installation file to your system.
2. The kit is activated with the optional switch /q or /q2.
The /q switch displays progress reports.
The /q2 switch does not display progress reports.
3. You must select a Management Mode by adding the mmode argument and the
ability to change that Management Mode by adding the change argument with
selected values as in the example below.
For example, at the command prompt type
elxocm-windows-x86-5.01.00.10-4.exe mmode=3 achange=1 /q2
The following are the possible mmode values:
1 – Local Only Management Mode
2 – Local Plus Management Mode
Commentaires sur ces manuels